Hull, Deck & Superstructure Construction:

• Oyster White W520 gelcoat. 
• Hand-laid laminated biaxial fiberglass hull and deck with Vinylester resin in the first layer.
• Deck to hull is thru bolted.
• Backing plates on all deck hardware.
• Awlgripped sheer and boot stripes.
• Artic White decks with off-white non-skid.
• Aluminum toe rail.
• 3 coats of epoxy on undersides at time of build.
• Double thick rub rail with stainless steel guard on rail.
• New bottom paint in 2025.

Keel & Rudder:

• Solid lead cast keel with stainless steel keel bolts.
• Shoal draft bulb keel - 5’2”.
• Rudder supported by high strength manganese bronze gudgeon and closed coupled to steel reinforced integral skeg.

Engine & Gearboxes:

• Yanmar 4JH3E - 56 HP.
• Engine hours 5,750 as of July 2025.
• Reverso Oil change pump in engine compartment.
• Duplex Racor filters.

Maintenance & Performance:

• Engine and systems regularly serviced.

Propulsion & Steering:

• Whitlock Pedestal steering with single lever engine control and En-guard offset pedestal guard.
• Stainless steel wheel with leather cover.
• Max Prop 3-blade propeller. 
• PSS dripless shaft seal by PYI.
• Evolution line cutter on shaft.
• Bow Thruster - 8HP Sidepower with joystick control mounted on pod next to autopilot (thruster duct flared at hull for reduced drag).

Voltage Systems:

• Balmar voltage regulator (2017).
• 12V outlet in starboard aft coaming box.
• 12V outlet at nav. station.
• AC/DC master power control panel (hinged for easy access). 
• Tinned copper wiring throughout.

Battery Banks:

• 3 x Lifeline AGM 4D house batteries (2020) - 610-amp hours. 
• Batteries located under floorboards between nav. station and galley (boat runs completely off house batteries).
• Spare Group 31 battery.

Battery Chargers:

• Ampair Pacific 100 wind generator.
• 3 x Sunpower 110W flexible solar panels with individual Victron BlueSolar MPPT 75/10 controllers.
• Balmar 210-amp alternator with double belt drive (May 2023).
• Magnum Energy MS2012-U sine wave inverter/charger with ME-RC remote control (2017).
• Magnum Energy ME-BMK Battery Monitor with shunt (2017).

Shore Power:

• 2 x Shore power cord/110V shorepower.

Other Electrical:

• Flexcharge controller.

Fresh Water & Water Heating System:

• Color coded water hoses/freshwater manifold.
• Six-gallon hot water heater from engine heat exchanger or shore power.

Bilge Pumps:

• PAR 34600-0000 electric bilge pump.
• Additional Rule pump and bilge alarm.
• Whale manual pump in cockpit.

Fuel:

• 265 liters (70 US gallon) fuel tank. 
• Fuel tank emptied and cleaned in 2016.

Fresh Water:

• Total water tankage 625 liters (165 US gallons).
• #1 tank under forward berth – 216 liters (57 US gal). 
• #2 tank at base of companionway – 227 liters (60 US gal). 
• #3 tank under aft berth – 182 liters (48 US gal).

Grey/Blackwater Holding Tanks:

• 76 liters (20 US gallon) holding tank (located under aft end of head countertop)
• Jabsco Sealed Macerator Pump – 2020.

• Full system upgrade in 2022.
• Iridium GO! system with fixed antenna (Satellite phone + data/weather offshore). Buyer responsible for subscription. 
• B&G Zeus3S 12" MFD + Halo20+ Radar at helm.
• B&G Zeus3S 9" MFD at nav. station.
• B&G NAC-3 Autopilot System, including:
  1. AP44 controller.
  2. Precision-9 compass.
  3. New autopilot drive (B&G RAM-T2-12V, installed Oct 2022).
  4. Rudder feedback sensor.
• B&G Triton² Instruments:
  1. Wind / Speed / Depth (masthead sensor, DST810 transducer).
  2. Three Triton² displays.
• B&G V60-B VHF with AIS transceiver (Class B — transmit & receive).
  1. Wireless handset.
  2. GPS antenna.
  3. AIS whip antenna mounted on mast.
• Ritchie steering compass SP-5.
• Clinometer.

Galley:

• Seagull IV A-1F water purifier at galley.
• Raw water spigot at galley with foot pump.
• Force Ten 3-burner propane stove with oven/broiler.
• Xintex propane sniffer, sensor mounted in galley below stove.
• SeaFrost BD3 12V DC refrigeration.
• Shutoffs for sink drain and deck wash under floorboard at galley sink.

Heads/Showers:

• Manual seawater Jabsco head.
• Hot/cold shower in cockpit coaming box with shut off valve.
• Corian Sierra/Sandstone countertops in head.
• Electric shower sump pump with overboard discharge.

Heating & Ventilation:

• Espar diesel heater with registers in main saloon, forecabin, aft cabin, and head.
• Chrome dorades.
• 6 x 12V Hella turbo fans.
• Ducting for 3 x registers for future a/c installation.

Entertainment:

• Clarion Audio system.

Lighting:

• All interior lighting refitted with LED bulbs.
• LED Anchor light.
• Forespar ML-2 LED Combination Deck / Steaming Light.

Summary of Accommodation:

• ACADIA features a classic, practical, and comfortable interior layout, designed for offshore cruising and extended living aboard. 
• Spacious saloon with large settees and dining table.
• A U-shaped galley.
• Two private staterooms with generous storage.
• Aft head with separate shower stall, easily accessible from companionway.
• Dedicated navigation station. 
• Varnished teak woodwork with white formica cabin house sides.
• Louvred doors.
• Teak and holly cabin sole.
• Push button locks on all lockers and drawers.
• Solid drop door on companionway entrance.

Description of layout:

Saloon:

• 6’5” headroom.
• The main saloon features a starboard-side U-shaped dinette and a port-side settee. 
• A teak drop-leaf table in the center provides dining for up to six and can be lowered to create a double berth.
• A 6’6” settee to port converts to a single berth.
• Ample storage beneath and behind the settees.
• Mast cover in matching fabric to cushions.

Forward and Aft Cabins:

• The forward cabin features the optional island double berth, with storage lockers and drawers. 
• The aft cabin features a double berth and storage lockers with drawers. Adjacent to the companionway, providing easy access to the cockpit, galley, and nav. station.

Galley:

• The U-shaped galley is located to starboard at the base of the companionway. It is equipped with a gimballed stove/oven, deep double sinks near the centerline, a large refrigerator/freezer, and extensive counter space and lockers for storage.
• Designed for offshore use, with secure handholds and ample counter space.
• Corian Sink countertops (Sierra/Sandstone with splash guard).
• Cutting board fitted to sinks.
• Tilt out trash bin.

Navigation Station:

• Opposite the galley to port, the navigation station features a forward-facing chart table, bookshelves, and storage.
• Dedicated nav. station houses the electronics’ panel, chart plotter, and VHF radio. 
• Teak navigation table.
• Four drawers at nav. station.

Head and Shower:

• The spacious head is located aft of the nav. station to port and features a separate shower stall, sink, and head with holding tank. The shower stall is notably large for a boat of this size, and there is a wet locker for foul-weather gear.
• The head is easily accessible from both the aft cabin and the main saloon.

Rig:

• Mast clearance 55’.
• I – 50.58,’ or 15.42m.
• J – 18.5,’ or 5.64m.
• P – 44.25,’ or 13.49m.
• E – 17.08,’ or 5.20m.
• Dutchman Boom Brake #500.
• Standing and running rigging inspected 2016.
• Cutter rig, aluminum.
• Double airfoil spreaders with six sheaves.
• 1 x 19 standing rigging.
• Built to PS “Single Handlers” Package.
• Solid boom vang with tackle/Forespar “yacht-rod,” large.
• Harken roller furling Unit 2.0 on headsail.
• Harken roller furling Unit 1.0 on staysail.
• Numerous Spinlocks, labelled.
• Insulated backstay.

Winches: 

• 2 x 53.2 STC Genoa sheet winches.
• 1 x 44.2 STC Mainsheet winch.
• 2 x 40.2 STC Halyard/utility winches.
• 1 x 40.2 STEC electric main halyard winch.

Sails: 

• Lightly used 120% Quantum high clew roller furling genoa with UV cover and foam luff – 2018.
• Quantum Mainsail, Dutchman system, 2 reefs (runs on a Tides Marine sail track and slide system attached to the mast) – 2012.
• 135% genoa, Bay Sails, lightly used – 2006.
• 120% high clew roller furling genoa with UV cover and foam luff, Ullman – original.
• Roller furling staysail with UV cover, Ullman – original.

General:

• Owner's manuals including the complete Pacific Seacraft 3-ring binder.
• Chrome deck hardware.
• Solid stern pulpit (no stern bathing ladder).
• SST handrails.
• SST ports.
• Sliding companionway hatch.
• Jackline clips.
• Custom swim ladder.
• Access to quadrant under helm seat.
• Raw water anchor deck wash located amidships starboard.
• Drink holder on pedestal.

Anchoring & Mooring Equipment:

• 45lb CQR anchor.
• Fortress FX37 anchor.
• Partitioned anchor rode locker; port side - 150ft. 5/16” high tensile chain spliced to 150ft 5/8” nylon rode; starboard side- chain and 150ft 5/8” nylon rode.
• Aft anchor locker – chain and 5/8” nylon rode.
• Muir electric windlass 1200 VRC (vertical) with two-foot switches, 5/16” rope/chain, with separate anchor deck pipe.

Covers, Canvas & Cushions:

• New Bimini (2023) with two interchangeable side panels and sunshade screens offering fill rain protection.
• Custom winter cover
• Bomar Hatch screens.
• Cockpit cushions, cream color.
• Spray dodger.
• Mosquito screens.
• Curtains (in locker).

Tender & Outboard:

• AB Marine 10UL 5-person inflatable RIB constructed with Hypalon for superior UV and weather resistance (2018).
• Yamaha 8HP outboard (2018).
• Stainless steel wind generator pole mount with crane for outboard motor hoist by Kato Marine.
• Outboard motor mount.

• EPIRB – ACR certified through 2020.
• Flares (current). 
• SSB copper grounding.
• Lightning ground system.

• Yanmar starter motor.
• Yanmar exhaust elbow.
• Yanmar (Hitachi) 80-Amp alternator (OEM).